Schneider Electric Magelis XBT GT User Manual download pdf (Page 174)

Troubleshooting

174

35010372 02 03/2006

Troubleshooting Checklists

Introduction When a problem occurs, make sure to go through the checklist and follow the

instructions given.

Here are the main potential problems which may occur when using the XBT GT unit are:

Panel display is blank,

Connected equipment cannot be used,

XBT GT does not respond or responds very slowly,

XBT GT beeps when powered on,

Cannot change the date or time.

Panel display is

blank

The table below gives you some solutions to adopt if the XBT GT unit display is

blank.

Note: If the following checklists do not solve your problem, please contact your

local Schneider Electric vendor or the vendor who sold you the XBT GT unit.

Step Check/Operation Solution

1 Are all Vijeo Designer screens

downloaded to the XBT GT unit?

You may have to download again the

screens again.

2 Is the Initial Panel ID set up correctly in

Vijeo Designer?

Enter the Initial Panel ID in the Vijeo

Designer editor and download again.

3 Is the unit using the correct rated

voltage?

Verify the power supply connections and

levels.

4 Is the power supply OFF or

disconnected?

Follow the instructions in this manual for

reconnecting the power supply.

5 Is the power lamp lit? A blank power lamp may indicate a

problem with the hardware.

6 Is the backlight lit? The backlight may be burned out or there

may be a problem with the unit. Contact

your local Schneider Electric distributor,

for backlight replacement.

7 Is the problem resolved? If none of the previous steps fixed the

blank panel display problem, then there is

a problem with the hardware.

1 2 ... 169 170 171 172 173 174 175 176 177 178 179 ... 189 190

Comments to this Manuals

No comments

Schneider Electric Magelis XBT GT User Manual Page 174

Comments to this Manuals