Maintenance
35010372 02 03/2006 183
Inserting the
Gasket
The gasket must be inserted correctly into the groove for the XBT GT's moisture
resistance to be equivalent to IP65.
The upper surface of the gasket should protrude approximately 2mm [0.08 inch] out
from the groove. Be sure to check that the gasket is correctly inserted before
installing the XBT GT into a panel.
Note: Be sure the gasket's seam is not inserted into any of the unit's corners. Insert
the joint only in the straight sections of the groove, preferably in the bottom section.
Inserting it into a corner may lead to its eventually tearing.
Comments to this Manuals