Schneider Electric Magelis XBT GT Technical Information download pdf (Page 49)

Controller States and Behaviors

EIO0000000638 04/2012 49

Legend:

z Controller states are indicated in ALL-CAPS BOLD

z User and application commands are indicated in Bold

z System events are indicated in Italics

z Decisions, decision results and general information are indicated in normal text

(1)

For details on STOPPED to RUNNING state transition, refer to Run Command

(see page 59).

(2)

For details on RUNNING to STOPPED state transition, refer to Stop Command

(see page 59).

Note 1

The Power Cycle (Power Interruption followed by a Power ON) deletes all output

forcing settings. Refer to Controller State and Output Behavior (see page 56) for

further details.

Note 2

The outputs will assume their initialization states.

Note 3

HMI download screen is displayed prompting the user to download the firmware,

HMI and Control application.

Note 4

The application is loaded into RAM after verification of a valid Boot application.

Note 5

The state of the controller will be RUNNING after a reboot if the reboot was provoked

by a Power Cycle and the HMI application

had been downloaded using a Multiple

Download... command with option Start all application after download or online

change selected.

Note 6

During a successful application download the following events occur:

z The application is loaded directly into RAM.

z By default, the Boot application is created and saved into the Flash memory.

1 2 ... 44 45 46 47 48 49 50 51 52 53 54 ... 123 124

No comments

Schneider Electric Magelis XBT GT Technical Information Page 49